Removal and Installation

REMOVAL AND INSTALLATION

CAUTION: When removing and installing the transmission control cable and shift lock cable unit, be careful not to hit the SRS-ECU.

REMOVAL SERVICE POINT
<> TRANSMISSION CONTROL CABLE ASSEMBLY REMOVAL

1. Support the transmission mount center member with a transmission jack, and then remove the transmission mount center member mounting bolts.
2. Lower the transmission so that there is enough room available to remove the transmission control cable assembly mounting nuts, and then remove the transmission control cable assembly mounting nuts.

INSTALLATION SERVICE POINTS
>>A<< RETAINER INSTALLATION

The bolt lengths differ according to where they are to be installed, so do not install them in the wrong place.

>>B<< TRANSMISSION CONTROL CABLE ASSEMBLY INSTALLATION
After installing the transmission control cable assembly, install the transmission mount center member mounting bolts and tighten them to the specified torque.
Tightening torque: 44 ± 10 Nm (33 ± 7 ft. lbs.)

>>C<< SHIFT LOCK CABLE UNIT INSTALLATION
1. Temporarily install the selector lever knob, and then move the selector lever to the "P" position and turn the ignition switch to the "LOCK" (OFF) position.





2. After installing the rod of the shift lock cable unit to the lock cam of the selector lever assembly, install the bolts of the shift lock cable unit.
3. Check the operation of the selector lever assembly.

INSPECTION








TRANSFER SHIFT LEVER SWITCH CONTINUITY CHECK <5A/T>