Compass Variance Adjustment

ADJUST FOR COMPASS VARIANCE




1. With showing the compass, keep pressing "M" switch for two seconds or more.
The current zone umber will appear upon release.




2. Find current location and variance zone number on the zone map.




3. Press the "H" switch repeatedly until the new zone number.




4. Pressing the "M" switch will exit zone entry mode. This area code number should remain in the battery off. If the compass deviates from the correct indication soon after repeated adjustment, have the compass checked at.

NOTE: Do not install the ski rack, antenna, etc., which are attached to the vehicle by means of a magnet. They affect the operation of compass.

NOTE: The compass may not indicate the correct compass direction in the place shown below:
- Tunnels
- Railroads
- Underpass/Overpass
- Transforming station
- Large metal structures
- Area over the subway

NOTE: The compass returns to the correct compass direction vehicle moves to an area where the geomagnetism is stabilized.