Transaxle Case
DISASSEMBLY AND ASSEMBLY
ASSEMBLY SERVICE POINTS
>>A<< BUSHING INSTALLATION
1. Press fit the bushing so the seam is away from the air vent.
2. Be sure the bushing is fully seated as shown. It must be 3 mm (0.12 inch) belong the housing surface.
>>B<< NEEDLE BEARING INSTALLATION
1. Check the installation direction of the needle bearing.
2. Press fit the needle bearing until it is flush with the case.
>>C<< OIL SEAL INSTALLATION
1. Apply gear oil (Hypoid gear oil SAE 75W-90 or 75W-85W conforming to API classification GL-4).
2. Using special tool MD998325