Electronic Throttle Actuator: Testing and Inspection

THROTTLE ACTUATOR CONTROL MOTOR CHECK

1. Disconnect the air intake hose from the throttle body.
2. Set the ignition switch to the ON position.
3. Operate the accelerator pedal and confirm that the throttle valve is opening and closing accordingly.

1. Disconnect the throttle position sensor connector.
2. Measure the resistance between terminal No. 5 and No. 6.
Standard value 0.3 - 100 Ohms [at 20 °C (68 °F)]

3. If resistance is outside the standard value, replace the throttle body assembly.