Learned Value Initialization Procedure

HOW TO INITIALIZE A/T LEARNED VALUE AIM
A/T learned value must be reset whenever the automatic transaxle, engine assembly, A/T valve body, or A/T solenoid valve is replaced. It cannot be reset by disconnecting the battery. Use the M.U.T.-III as follows:

INITIALIZATION PROCEDURE
1. Move the selector lever to the P range and turn the ignition switch to the LOCK (OFF) position. Then, connect M.U.T.-III to the diagnosis connector.
2. Turn the ignition switch to the ON position, and then move the selector lever to the R range.
3. Depress the accelerator pedal while depressing the brake pedal. (Engine stops.) Perform the operation to erase the DTC under this condition (even if no codes are set).

NOTE: This reset procedure will also automatically initialize the INVECS-II Learned Value. A/T DTCs and A/T freeze-frame data will be erased. (Engine DTCs, engine-related freeze-frame data, and Readiness status will remain even after A/T Learned Value is reset.)