Engine Idling Learning Procedure

ENGINE IDLING LEARNING PROCEDURE

PURPOSE
When the ECM is replaced, or when the learned value is initialized, the idle may not be stabilized. Carry out the learning method by following the procedures below.

LEARNING PROCEDURE
1. Start the engine and warm to reach 80°C (176°F) or more.

NOTE: When the engine coolant temperature is 80°C (176°F) or more, the warm-up is not needed if the ignition switch is in "ON" position once.

2. Turn the ignition switch to "LOCK" (OFF) position.
3. After 10 seconds or more, start the engine again.
4. For 10 minutes, carry out the idling under the condition shown below and then confirm the engine idles normally.
^ Transaxle: Neutral (P range on vehicles with CVT or TC-SST)
^ Operation in ignition-related, fan and attachments: Not to be operated
^ Engine coolant temperature: 80°C (176°F) or more

NOTE: If the engine stalls while idling, check for a dirty (on the throttle valve) of the throttle body and clean if needed. Then perform the service from Procedure 1 again.