Connecting Rod, Engine

Measure the outside diameter "A."
Measure the smallest outside diameter "B" within the range "X".
If the difference of outside diameter of thread exceeds the limit, replace the connecting rod bolt.
Limit 0.1 mm (0.004 inch)

Tightening Sequence
After installing each bolt and tightening it by fingers, tighten bolts alternately.
Tighten the bolt in several steps 5.0 Nm (44 in-lb)
Tighten the bolt in several steps 20 Nm (15 ft-lb)
Tighten the bolt 90°

Clearance of Connecting Rod Big End Thrust
Standard Value 0.10 - 0.25 mm (0.004 - 0.010 in.)
Limit 0.4 mm (0.016 in.)

Connecting Rod Bearing Oil Clearance
Standard Value 0.018 - 0.045 mm (0.0007 - 0.0018 in.)
Limit 0.1 mm (0.004 in)