Removal and Replacement

REMOVAL AND INSTALLATION













REMOVAL SERVICE POINT

[[A]] TRANSFER ASSEMBLY REMOVAL

Move the engine and transaxle assembly toward the front of the vehicle to make a gap between the engine/transaxle assembly and the crossmember. Pull out the transfer assembly through this gap.

INSTALLATION SERVICE POINT

]]A[[ EXHAUST MANIFOLD BRACKET B INSTALLATION





1. Make sure that the exhaust manifold bracket is closely contacted with the exhaust manifold and transfer assembly, and then temporarily tighten the bolts.
2. Tighten bolt A on the exhaust manifold side in the figure to the specified torque.
Tightening torque: 20 ± 5 Nm (15 ± 3 ft-lb)
3. Tighten bolt B on the transfer assembly side in the figure to the specified torque.
Tightening torque: 20 ± 5 Nm (15 ± 3 ft-lb)