Removal And Installation For Compressor

REFRIGERANT LINES


Removal and Installation for Compressor

Compressor Mounting






REMOVAL
1. Discharge the refrigerant. Refer to HFC-134A (R-134A) Service Procedure.
2. Remove the engine under cover and the splash shield.
3. Remove the drive belt. Refer to Service and Repair.
4. Remove the compressor mounting stud.
5. Disconnect the compressor connector.
6. Disconnect the high-pressure flexible hose and low-pressure flexible hose from the compressor.

CAUTION:
Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.
7. Remove the compressor bolts and nut using power tools.

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
- Replace the O-ring of the low-pressure flexible hose and high-pressure flexible hose with a new one, then apply compressor oil to it when installing it.
- After charging refrigerant, check for leaks.