Interior - Wind Noise At A Pillar
Reference: TECHNICAL BULLETIN TS87-042 Date: March 9, 1987Classification: BF87-007 Section: Body & Frame Models: 1984-1987 200SX
WIND NOISE
APPLIED MODEL: 1984-1987 200SX
SERVICE INFORMATION
Some 1984-1987 200SX vehicles may exhibit wind noise (buzzing sound) around the "A" pillar. This noise usually occurs when cross-wind conditions exist. If the door is properly adjusted and the wind noise still exists, add a bead of black RTV silicone adhesive/sealant and butyl to the body side weatherstrip as described below.
SERVICE PROCEDURE
Body Side Weatherstrip:
1. With the door open, clean the trough of the body side weatherstrip with a solvent (alcohol or equivalent) that leaves no residue.
Weatherstrip Indications:
2. Apply a continuous bead of black RTV silicone adhesive/sealant (GE, Dow or equivalent) along the indicated portion (A and B) of the weatherstrip as shown below. Wet finger with water and smooth the silicone as required.
NOTE: Silicone should fill indicated portion (A and B) to be effective.
3. Remove the lower weatherstrip retaining clip and add a bead of butyl to the indicated portion (C) of the weatherstrip as shown below. Replace the retaining clip.
4. Remove excess silicone with a dry paper towel and close the door.
WARRANTY INFORMATION
CS PNC CT OP CODE FLAT RATE
4R 80830 34 RF99AC 0.2/hr. - one door
RF99AD 0.3/hr. - both doors