Storing / Erasing Memory Position

Procedure For Storing Keyfob:

PROCEDURE FOR STORING MEMORY POSITION

NOTE: The stored memory positions are maintained unless battery power is disconnected from memory seat and mirror control unit.
Two different positions are memorized for positions 1 and 2 in the memory seat and mirror control unit initially. After the battery power supply is disconnected and reconnected, the memories of positions will return to the initial memorized positions.
GIf the current position is the programmed position for that switch, the position will not be re-programmed.
If a sensor is not valid, the memory of axis position will not be changed. Only the position of motors with a valid sensor will change to new positions.


Procedure for Erasing Keyfob Memory
Hold both memory switch 1 and 2 then push UNLOCK switch on the keyfob to be deprogrammed.

NOTE: In this case auto back function will not operate.