Fail-Safe System Check
Fail-Safe System Check1. Turn ignition switch to ON position.
2. Turn ASCD MAIN switch to ON and check if the "SET" indicator blinks.
If the indicator lamp blinks, refer to the following
ASCD Steering Switch Check.
ASCD Steering Switch Circuit Check
3. Drive the vehicle at more than 40 km/h (25 MPH) and push SET/COAST switch.
If the indicator lamp blinks, refer to the following
Vehicle Speed Sensor Check.
Vehicle Speed Sensor Check
ASCD Actuator Circuit Check.
ASCD Motor Actuator Circuit Check
Replace control unit.
4. Depress brake pedal slowly (brake pedal should be depressed more than 5 seconds).
If the indicator lamp blinks, refer to the following
ASCD Brake/Stop Lamp Switch Check.
ASCD Brake/Stop Lamp Switch Circuit Check
5. END. (System is OK.)