Connecting Rod Bolt Torque Sequence

1- Tighten the connecting rod nuts in two stages:
Stage 1: 19 - 21 Nm (1.9 - 2.1 kg-m, 14 -15 ft. lbs.)
Stage 2: 90° - 95° degrees clockwise

CAUTION: Always use either an angle wrench or protractor. Avoid tightening based on visual check alone.
^ Apply engine oil to the threads and seats of the connecting rod bolts and nuts.
^ After tightening the nuts, make sure that the crankshaft rotates smoothly.
^ Check the connecting rod side clearance. If beyond the limit, replace the connecting rod and/or crankshaft.

Connecting rod side clearance:
Standard: 0.20 - 0.35 mm (0.0079 - 0.0138 inch)
Limit: 0.40 mm (0.0157 inch)