Brake Fluid Level Sensor System

Brake Fluid Level Sensor System Inspection

INSPECTION PROCEDURE
1. SELF-DIAGNOSIS RESULT CHECK
1. Check the brake reservoir tank fluid level. If the level is low, add brake fluid.
2. Erase the self-diagnosis results and check the self-diagnosis results.





Is the above displayed in the self-diagnosis display items?
Yes >>GO TO 2.
No >>INSPECTION END.

2. CONNECTOR INSPECTION
1. Turn the ignition switch off and disconnect the ABS actuator and electric unit connector E125 and brake fluid level sensor connector E21.
2. Check the terminals for deformation, disconnection, looseness or damage.
OK or NG
OK >>GO TO 3.
NG >>Repair or replace as necessary.

3. CHECK THE HARNESS BETWEEN THE BRAKE FLUID LEVEL SENSOR AND THE ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)





Check the continuity between the brake fluid level sensor connector E21 and the ABS actuator and electric unit (control unit) connector E125.
OK or NG
OK >>Connect the connectors and conduct a ABS actuator and electric unit self-diagnosis.
NG >>Repair the circuit.