A/T, Engine Controls - Low Power/No MIL/DTC P0868: Overview
Classification: AT05-009aReference: NTB05-084a
Date: November 20, 2006
MURANO; LACK OF POWER ON TAKE OFF WITH DTC P0868 STORED IN THE TCM AND NO MIL ON
This bulletin has been amended. The Applied Vehicles have been updated.
Please discard all previous copies of this bulletin.
APPLIED VEHICLES:
2003 - 2007 Murano (Z50)
IF YOU CONFIRM
A lack of power when accelerating from a standing start.
With
DTC P0868 stored in the TCM but no MIL ON.
ACTIONS
Step A: Remove the original valve body and install the parts listed in the Parts Information section of this bulletin.
IMPORTANT:
Make sure to erase the EEPROM.
Step B: Reprogram the TCM.
PRECAUTIONS WHEN REPLACING CVT VALVE BODY ASSEMBLY
1. If other DTCs are combined w/P0868, resolve them first. Refer to ASIST and the Service Manual for diagnostic information.
2. If you observe excessive contamination in the oil pan and/or can isolate an unusual noise coming from the transmission, this TSB does not apply. Refer to the Service Manual for further assistance.
3. Transmissions are very vulnerable to particles (dust, metal, etc.).
^ When replacing a CVT valve body, make sure your work environment (shop, workbench, etc.) the transmission area (sub-frame, oil pan, harness connector, etc.) and your hands are free of contamination.
^ Make sure all parts are clean prior to installing on the vehicle.
^ Unpack Service Parts just before installation.
IMPORTANT:
The purpose of ACTIONS" (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire Service Procedure as it contains information that is essential to successfully completing this repair.
PARTS INFORMATION
CLAIMS INFORMATION
Submit a Primary Failed Part (PP) line claim using the claims coding table.
Disclaimer