Procedure A: ECM Reprogramming

PROCEDURE A: ECM REPROGRAMMING

Before beginning reprogramming, use CONSULT-II to make sure there are no DTCs stored in the ECM.

Repairs for stored DTCs must be done before performing the ECM reprogramming. Use ASIST for DTC diagnostic and repair information.

Repairs for stored DTCs are not related to this campaign.

Reprogramming should be performed by an OBD-II Certified technician





1. Compare your vehicle's ECM P/N to those shown under Current ECM P/N in Chart A.

2. If your vehicle's current ECM P/N matches one of the Current ECM P/N's in Chart A:

^ Perform ECM reprogramming. (Detailed steps of ECM reprogramming are in Appendix B).

^ Make sure to connect a battery charger to the vehicle battery and set it to a low charge rate (trickle charge) during the ECM reprogramming.

3. If your vehicle's ECM P/N does not match one of the Current ECM P/N's in Chart A:

^ This campaign may not apply or has already been done on this vehicle.

^ Recheck Service Comm (campaign ID PB023) to confirm the vehicle you're working on is affected by this campaign.