Rod Bearing Cap

Rod Bearing Cap





Tighten the connecting rod bolts using Tool in four steps as follows:
Apply engine oil to the threads and seats of the connecting rod bolts.

CAUTION: Always use either an angle wrench or protractor. Avoid tightening based on visual check alone.

Step 1 18.6 - 20.6 Nm (1.9 - 2.1 kg-m, 14 - 15 ft. lbs.)
Step 2 85° - 95° (target 90° degrees)
Check the connecting rod side clearance.
After tightening the bolts, make sure that the crankshaft rotates smoothly.

OUTER DIAMETER OF CONNECTING ROD BOLT





^ Measure outer diameter (d) at position shown.
^ When "d" exceeds the limit (when it becomes thinner), replace the bolt with a new one.
Limit 7.75 mm (0.3051 inch) or less