Removal And Installation

ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)


Removal and Installation


CAUTION:
- Before removal, disconnect the battery negative terminal.
- To disconnect the brake tubes, use a flare nut wrench to prevent the flare nuts and brake tubes from being damaged. To connect the brake tubes, use a flare nut torque wrench to tighten to the specified torque.
- Do not drop the ABS actuator and electric unit (control unit).
- Do not remove and install the ABS actuator and electric unit (control unit) by holding it by the harness.
- After installation, bleed the air from the brake lines. Refer to Service and Repair.

REMOVAL
1. Disconnect the battery negative terminal.
2. Drain the brake fluid. Refer to Removal and Replacement.

CAUTION:
Do not reuse the brake fluid.
3. Remove the front wiper arms. Refer to Removal and Installation.
4. Remove the cowl top and RH cowl top extension. Refer to Removal And Installation.
5. Disconnect the wiper washer hose.
6. Remove the tower bar. Refer to Exploded View.
7. Disconnect the ABS actuator and electric unit (control unit) connector.
8. Loosen the brake tube flare nuts, then disconnect the brake tubes from the ABS actuator and electric unit
(control unit).
9. Remove the ABS actuator and electric unit (control unit) nuts.
10. Remove the ABS actuator and electric unit (control unit).
11. Remove the ABS actuator and electric unit (control unit) bracket as necessary.

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
Perform the neutral position adjustment for the steering angle sensor. Refer to Description Special Repair Requirement Description Special Repair Requirement.