Operation CHARM: Car repair manuals for everyone.
Home >> Nissan-Datsun >> 2011 >> Maxima V6-3.5L (VQ35DE) >> Repair and Diagnosis >> Body and Frame >> Frame >> Subframe >> Rear Subframe >> Service and Repair >> Removal And Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Removal And Installation





REAR SUSPENSION ASSEMBLY


Removal and Installation


Removal

CAUTION:
Before removing the rear suspension assembly, disconnect the ABS wheel sensor from the assembly.
Failure to do so may result in damage to the sensor wires and the sensor becoming inoperative.
1. Remove the center exhaust tube with muffler(s). Removal And Installation.
2. Remove brake caliper assembly and reposition aside, without disconnecting the hydraulic hose, using power tools. Removal And Installation.
- Leave the brake hydraulic hose connected to the brake caliper.
- Do not depress the brake pedal, or the caliper piston will pop out.
- Do not pull or twist the brake hydraulic hose.
3. Remove the brake rotor.
4. Disconnect parking brake cable from knuckle. Exploded View.
5. Remove rear wheel sensors. Wheel Sensor.
6. Remove lower shock absorber nuts using power tools.
7. Remove rear lower link. Rear Lower Link & Coil Spring.
8. Remove upper ball joint nut and cotter pin. Exploded View.
9. Disconnect radius rod member side. Service and Repair.
10. Disconnect front lower link. Front Lower Link.
11. Remove knuckle using Tool. Exploded View.






CAUTION:
- Do not damage ball joint when removing.
- While using Tool, temporarily tighten the nut so as not to damage screw threads.
12. Remove stabilizer bar. Rear Stabilizer.
13. Disconnect member harness.
14. Support rear suspension using suitable jack.
15. Remove the suspension member nuts and member stay bolts using power tools.
16. Use the jack to support and lower the rear suspension assembly for removal.

Installation
Installation is in the reverse order of removal.
- Check the rear wheel alignment and adjust if necessary. .
- Install member stays in correct position.

NOTE:
Member stays are directional.
pro multis · About Operation CHARM