Operation CHARM: Car repair manuals for everyone.
Home >> Nissan-Datsun >> 2011 >> Maxima V6-3.5L (VQ35DE) >> Repair and Diagnosis >> Body and Frame >> Mirrors >> Power Mirror Position Switch/Sensor >> Testing and Inspection >> Driver Side
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Driver Side


MIRROR SENSOR:_:DRIVER SIDE





Description
- The mirror sensor LH is installed to the door mirror LH.
- The resistance of 2 sensors (horizontal and vertical) is changed when the door mirror LH is operated.
- Automatic drive positioner control unit calculates the door mirror position according to the change of the voltage of 2 sensor input terminals.




Component Function Check
1. CHECK FUNCTION
1. Select "MIR/SEN LH U-D", "MIR/SEN LH R-L" in "Data monitor" with CONSULT-III.
2. Check mirror sensor (driver side) signal under the following condition.





Is the indication normal?
YES - Inspection End.
NO - Perform diagnosis procedure. SEE Diagnosis Procedure.




Diagnosis Procedure
Regarding Wiring Diagram information, Electrical Diagrams.
1. CHECK DOOR MIRROR LH SENSOR SIGNAL





1. Turn ignition switch to ACC.
2. Check voltage between door mirror LH harness connector and ground.





Is the inspection result normal?
YES - GO TO 5
NO - GO TO 2
2. CHECK DOOR MIRROR LH SENSOR CIRCUIT 1





1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit and door mirror LH connector.
3. Check continuity between automatic drive positioner control unit harness connector and door mirror LH harness connector.





4. Check continuity between automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES - GO TO 3
NO - Repair or replace harness.
3. CHECK DOOR MIRROR LH SENSOR CIRCUIT 2





1. Check continuity between automatic drive positioner control unit harness connector and door mirror LH harness connector.





2. Check continuity between automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES - GO TO 4
NO - Repair or replace harness.
4. CHECK TILT MOTOR ADJUSTING OPERATION
1. Connect automatic drive positioner control unit and door mirror LH.
2. Turn ignition switch ON.
3. Check tilt motor adjusting operation with memory function.
Is the operation normal?
YES - Replace door mirror actuator. (Built in door mirror LH). Removal And Installation.
NO - Replace automatic drive positioner control unit. Service and Repair.
5. CHECK INTERMITTENT INCIDENT
Intermittent Incident.
Is the inspection result normal?
YES - Replace automatic drive positioner control unit. Service and Repair.
NO - Repair or replace the malfunctioning part.
pro multis · About Operation CHARM