Wrap Up (Complete the Procedure)

1. Close the software (C-III plus, C11 Odometer Calibration Tool, and ASIST).

2. Disconnect the combination meter from the meter Reprogramming Tool.

3. Disconnect the reprogramming meter cable from the vehicle.

4. Disconnect the Reprogramming Tool from the CONSULT PC.

5. Reinstall the combination meter in reverse of removal.

CAUTION:

Be careful; do not scratch the clear meter lens.

6. Turn the ignition ON.

7. Make sure the mileage on the odometer matches the Calibrated Mileage on the Calibration Completion Report (see example - Figure 1n).

8. Clear DTCs that stored during the meter reprogramming.

a. Confirm the VI is still connected to the vehicle's DLC.

b. Open/launch C-III plus.





c. Wait for the plus VI to be recognized.

^ Serial number will display when the plus VI is recognized.





d. Select Diagnosis (All Systems).

e. Make sure VIN or Chassis # matches the vehicle's VIN.





f. Select Confirm.

g. Wait for System Call to complete.





h. Select Erase.

9. Close C-III plus.

10. Turn OFF the CONSULT PC.

11. Disconnect the VI.

12. Turn the ignition OFF.

13. Disconnect the battery charger from the vehicle battery.

END