Camshaft Position Sensor: Service and Repair
INTAKE VALVE TIMING CONTROL
Camshaft Position Sensor (PHASE)
REMOVAL
1.Remove engine room cover using power tool. Service and Repair.
2.Remove air duct and resonator assembly. Removal And Installation.
3.Disconnect camshaft position sensor connector.
4.Remove camshaft position sensor (2) and O-ring (3) from Intake valve timing control solenoid valve cover (LH) (1).
CAUTION:
Do not reuse O-ring.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
- Lubricate O-ring with engine oil before installing.
- Do not reuse O-ring.
Camshaft position sensor bolt: 9.0 Nm (0.92 kg-m, 80 in-lb)