Foot Position Setting Trimmer

SYSTEM SETTING

Foot Position Setting Trimmer


DESCRIPTION

In FOOT mode, the air blowing to DEF can be turned ON/OFF.

HOW TO SET

1.Starts on board self-diagnosis STEP 5 mode (Each sensor recognition temperature check; "51" or "52" is indicated on front A/C control display).
2.Press fan switch (up: +) and check that "61" is indicated on front A/C control display.
3.After approximately 3 seconds, the foot position setting trimmer can be available.
4.Press MODE switch to select FOOT mode type as shown below.





NOTE:
When the battery cable is disconnected from the negative terminal or when the battery voltage becomes 10 V
or less, the setting of the foot position setting trimmer may be cancelled.