Operation CHARM: Car repair manuals for everyone.
Home >> Nissan-Datsun >> 2012 >> Rogue 2WD L4-2.5L (QR25DE) >> Repair and Diagnosis >> Body and Frame >> Locks >> Keyless Entry >> Keyless Entry Transmitter >> Service and Repair >> Keyfob Battery >> Removal And Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Removal And Installation




KEYFOB BATTERY

Removal and Installation


REMOVAL

1.Remove screw (9) on the rear of keyfob.
2.Place the key with the lower case (8) facing up. Set a screw-driver wrapped with tape between upper case (1) and lower case (8) and then separate the lower case (8) from the upper case (1).

CAUTION:
- Do not touch the circuit board or battery terminal.
- The keyfob is water-resistant. However, if it does get wet, immediately wipe it dry.
3.When replacing the circuit board assembly, remove circuit board assembly from the upper case (1).
[Circuit board assembly: Switch rubber (4) + Board surface (5)]

CAUTION:
Do not touch the printed circuits directly.
4.Remove the battery (6) from the lower case (8) and replace it.
Battery replacement: Coin-type lithium battery
(CR1620)

CAUTION:
When replacing battery, keep dirt, grease, and other foreign materials off the electrode contact area.
5.After replacement, fit the lower and upper cases together, part (4), (7) and tighten with the screw.

CAUTION:
After replacing the battery, Be sure to check that door locking operates normally using the keyfob.
Keyfob Battery.

INSTALLATION

Install in the reverse order of removal.
pro multis · About Operation CHARM