Programming Procedure

Coding The Transmitter:

^ Do the following procedure whenever the Data Encoder connector is grounded, the Keyless Entry Module is replaced, the portable transmitter is replaced or a second transmitter is needed.

1. Jumper the Data Encoder connector to ground (all power door locks will lock and unlock).
2. Operate transmitter by pressing a single button once.
3. To program a second portable transmitter, operate transmitter 2 by pressing a single button once. In order for programming to be complete, wait after each button is pressed for the locks to fully cycle.
4. Disconnect Data Encoder Jumper Connector after locks have finished cycling.
5. Verify that the portable transmitter(s) operate door locks and luggage compartment release.