Catalytic Converter: Service and Repair

3 Way Converter Attachment:

REMOVAL:

1. Raise vehicle.
2. Support converter.

NOTE: Cuts must be made as close to weld as possible to ensure adequate overlap for clamping.

3. Cut front exhaust pipe at converter.
4. Remove bolts intermediate exhaust pipe at converter.
5. Remove converter.

INSTALLATION:

1. Install clamps to replacement converter. (DO NOT tighten clamp nuts yet.)
2. Install converter.
3. Tighten clamp nuts to 50 Nm (37 ft lb).
4. Install bolts intermediate exhaust pipe to converter.
5. Tighten bolts to 30 Nm (20 ft lb).
6. Lower vehicle.