Crankshaft Position Sensor Replacement (3X)

3X Crankshaft Position Sensor:

REMOVE OR DISCONNECT
1. Disconnect negative battery cable.
2. Starter Motor.
3. Sensor harness connector at module.
4. Sensor to block bolt (1).
5. Sensor from engine.


INSPECT
Sensor 0-ring for wear, cracks or leakage. Replace if necessary. Lube new 0-ring with clean engine oil before installing.


INSTALL OR CONNECT
1. Sensor into hole in block.
2. Sensor to block bolt (1).

Tighten
Torque to 8 Nm (71 lb in).

3. Sensor harness connector at sensor.
4. Starter Motor.
5. Negative battery cable.