Power Window Motor

Tool Required
J 20922-A Rivet Installer

Remove or Disconnect

^ Raise the window to the closed position and secure the glass to the door frame using cloth-backed tape.
1. Negative battery cable.
2. Trim panel.
3. Water deflector from the door.
4. Electrical connector from motor.
5. Regulator and motor assembly from the window mount sash.

CAUTION: Sector gear must be locked into position. Regulator lift arm is under tension from the counterbalance spring and could cause personal injury if the sector gear is not locked in position.

6. Motor from window regulator.

Installing Bolt To Lock Sector Gear:

A. Install bolt and nut to lock sector gear in position.
B. Drill out the motor mounting rivets.

Install or Connect

1. Motor to the regulator.
2. Rivets to the motor and regulator using tool J 20922-A.
^ Install 4.8 mm (3/16 in.) rivets.

Important
^ Remove nut and bolt used to lock the sector gear in position.

3. Regulator and motor assembly to the window mount sash.
4. Electrical connector to the motor.
5. Water deflector.
6. Armrest bracket.
7. Water deflector.
8. Trim panel.
9. Negative battery cable.