Ignition Control Module: Service and Repair

Removal Procedure
1. Remove all the electrical connectors at the ignition control module.
2. Note position of spark plug wires for installation
3. Remove the secondary ignition wires from ignition coils.
4. Remove the screws securing coil assemblies to ignition control module.
5. Remove the fasteners securing ignition control module assembly to engine.
6. Remove ignition control module.

Installation Procedure
1. Install the coils to ignition control module.
2. Install the screws.

Tighten
^ Tighten the screws to 4-5 Nm (40 lb in).

3. Install the fasteners securing assembly to engine.

Tighten
^ Tighten the fasteners to 8 Nm (70 lb in).

4. Install the spark plug wires as noted during removal.
5. Install the electrical connectors to the ignition control module.