A/T Range Selector Cable Lever Replacement

REMOVAL PROCEDURE





1. Remove the throttle body air inlet duct.
2. Use a large flat-bladed tool in order to remove the automatic transaxle range selector lever cable from the automatic transaxle range selector lever.





3. Remove the automatic transaxle range selector lever nut.
4. Remove the automatic transaxle range selector lever.

INSTALLATION PROCEDURE





1. Install the automatic transaxle range selector lever.
2. Install the automatic transaxle range selector lever nut.
^ Tighten the automatic transaxle range selector lever nut to 20 Nm (15 lb ft).

NOTICE: Refer to Fastener Notice in Service Precautions.





3. Install the automatic transaxle range selector lever cable to the automatic transaxle range selector lever.
4. Adjust the automatic transaxle range selector lever cable if necessary.
5. Install the throttle body air inlet duct.