Compressor Control Switches Removal (HT6/HD6)

TOOLS REQUIRED
^ J 39500-B R-134a A/C Refrigerant Recovery, Recycling and Recharging System (ACR4)
^ J 5403 Snap Ring Pliers
^ J 9553-01 O-Ring Remover
1. Recover the refrigerant using the J 39500-B.
2. Disconnect the electrical connector from the switch (2) in the rear head of the compressor.
3. Remove the switch retaining ring using the J5403.
4. Remove the switch (2) from the compressor.
5. Remove the old O-ring seal from the switch cavity using the J 9553-01.
6. Inspect the switch cavity and the O-ring groove in the rear head for dirt or foreign material. Clean the components as necessary.