Crankshaft Position Sensor: Service and Repair

REMOVAL PROCEDURE
1. Turn OFF the ignition switch.
2. Turn the steering wheel fully to the left.

CAUTION: Refer to Vehicle Lifting Caution in Service Precautions.

3. Raise the vehicle.
4. Disconnect the sensor electrical connector.
5. Remove the attaching Bolt/screw.
6. Remove the sensor from engine.
7. Inspect for wear, cracks, or leakage if the sensor is not being replaced.

INSTALLATION PROCEDURE
1. Install the sensor to the block.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the bolt to hold sensor to block face.

Tighten
Tighten the bolt to 8 N.m (71 lb in).

3. Connect the electrical connector.
4. Lower the vehicle.