Visual/Physical Check

Several of the symptom procedures call for a visual/physical inspection. A careful visual/physical inspection can aid in correcting a problem without further checks and can save valuable time. A visual/physical inspection should include the following items:
^ PCM grounds for being loose, corroded, or in an improper location.
^ Vacuum hoses for splits, kinks, and improper connections. The proper connections are shown on the Vehicle Emission Control Information label. Check the vacuum hoses for any type of leak or restriction.
^ Inspect the air intake ducts for collapsed or damaged areas.
^ Check for air leaks at throttle body mounting area, Mass Air Flow (MAF) sensor, and intake manifold sealing surfaces.
^ Inspect the ignition wires for cracking, hardness, proper routing and carbon tracking.
^ Inspect the wiring for improper connections, pinches and cuts.

The following Symptom tables are located in this section:
^ Intermittent Conditions
^ Hard Start
^ Surges/Chuggles
^ Lack of Power; Sluggishness, or Sponginess
^ Detonation/Spark knock
^ Hesitation, Sag, Stumble
^ Cuts Out, Misses
^ Poor Fuel Economy
^ Rough, Unstable, or Incorrect Idle and Stalling
^ Dieseling, Run-On
^ Backfire
^ Restricted Exhaust System Check