Antitheft Relay: Service and Repair

REMOVAL PROCEDURE
1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
2. Remove the IP assembly.
3. Remove the following components from the stud:
^ The fastener
^ The starter enable relay (1)
4. Disconnect the starter enable relay connector.
5. Remove the starter enable relay (1).

INSTALLATION PROCEDURE
1. Install the starter enable relay connector. Position the relay (1) over the stud.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the fastener to the stud.

Tighten
Tighten the fastener to 4.5 N.m (40 lb in).

3. Install the IP assembly.
4. Enable the SIR system. Refer to Enabling the SIR System in SIR.