Steering Mounted Controls Transmitter: Service and Repair
REMOVAL PROCEDURE1. Remove the inflatable restraint steering wheel module.
2. Remove the [1][2]steering wheel controls retaining screws from the back of the inflatable restraint steering wheel module.
3. As necessary, remove the horn switch ground wire connector from the grounding bracket to allow removal of the [1][2]steering wheel controls wire harness.
4. Remove the [1][2]steering wheel controls wire harness connector from the retainer.
5. Remove the [1][2]steering wheel controls switches and harness from the inflatable restraint steering wheel module.
INSTALLATION PROCEDURE
1. Install the [1][2]steering wheel controls switches and harness to the inflatable restraint steering wheel module.
2. Install the [1][2]steering wheel controls wire harness connector to the retainer on the inflatable restraint steering wheel module.
3. Route the [1][2]steering wheel controls harness on the inflatable restraint steering wheel module and if necessary, re-connect the horn switch ground connector to the ground bracket.
NOTE: Refer to Fastener Notice in Cautions and Notices.
4. Install the [1][2]steering wheel controls retaining screws.
Tighten
Tighten the retaining screws to 2 N.m (18 lb in).
5. Install the inflatable restraint steering wheel module.