Keyless Entry Receiver: Service and Repair

REMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.
2. Open the rear compartment lid.
3. Remove the remote door lock receiver. The receiver is located between the rear package shelf and the rear package shelf cover, just to the right of the center access hole. Compress the four tabs and slide the receiver down through the access hole.
4. Disconnect the electrical connector.

INSTALLATION PROCEDURE




1. Connect the electrical connector.
2. Install the receiver through the access hole. Ensure that the mounting tabs are snapped into place.
3. Close the rear compartment lid.
4. Reprogram the new receiver to transmitter(s). Refer to Transmitter Synchronization. Transmitter Synchronization