Torque Converter: Service and Repair
Flywheel to Torque Converter BoltReplacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the starter.
3. Remove the converter housing access plug.
4. Mark the converter and flywheel for proper alignment for installation.
5. Remove the flywheel to converter bolts.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the flywheel to converter bolts. Hand start the bolts.
Tighten the bolts to 60 Nm (44 ft. lbs.).
2. Install the converter housing access plug.
3. Install the starter.
4. Lower the vehicle.