Oil Pressure Sensor: Service and Repair
ENGINE OIL PRESSURE SENSOR OR SWITCH REPLACEMENTREMOVAL PROCEDURE
1. Disconnect the battery ground (negative) cable.
2. Raise and suitably support the vehicle.
3. Disconnect the electrical connector from the engine oil pressure switch. Refer to LX5 - Engine Component Views (Bank 1).
4. Remove the engine oil pressure switch.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the engine oil pressure switch. Refer to LX5 - Engine Component Views (Bank 1).
Tighten
Tighten the engine oil pressure switch to 10 N.m (89 lb in).
2. Connect the electrical connector to the engine oil pressure switch. Refer to LX5 - Engine Component Views (Bank 1).
3. Lower the vehicle.
4. Connect the battery ground (negative) cable.
"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID". RPO Codes