- General Information -

During Body Control Module (BCM) related service, the procedures below are designated to set-up the BCM correctly. Before you start, read these carefully and completely.

IMPORTANT: The following procedures must be followed:
^ Read this procedure carefully and completely.
^ The BCM will not function properly if the Setup New BCM procedure is not performed.
^ Make sure the battery is fully charged.
^ Make sure all disconnected devices and connectors are reconnected.
^ Perform the Programming Theft Deterrent System Components in Theft Deterrent after successfully finishing the Setup New BCM procedure. If the Programming Theft Deterrent System Components procedure is not performed after a BCM replacement, one of the following conditions will occur:
- The vehicle will not be protected against theft by the Passlock Sensor system.
- The engine will not crank nor start.