Rear Door Window Regulator: Service and Repair

Window Regulator Replacement - Rear Door

Removal Procedure





1. Lower the window half way down in order to gain access to the window retainer clamp fasteners (1).
2. Remove the door trim panel. Refer to Trim Panel Replacement - Side Rear Door Service and Repair.
3. Remove the door module.
4. Remove the water deflector. Refer to Water Deflector Replacement - Rear Door (Service and Repair) .
5. Loosen the window retainer clamp fasteners.

Important: You may need to use masking tape in order to hold the window in place while removing the regulator.


6. Slide the window to the full up position.
7. Disconnect the electrical connector from the motor.
8. Remove the window regulator to inner door panel fasteners (1-3).
9. Remove the window regulator.



Installation Procedure





1. Install the window regulator into the door.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the window regulator fasteners.

Tighten the fasteners in this order, (1, 3, 2), to 9 N.m (80 lb in).

3. Provide power to the window motor and run the motor to the fully closed position.

Tighten the window retainer clamp fasteners to 11 N.m (95 lb in).

4. Connect the window motor electrical connector.
5. Install the water deflector. Refer to Water Deflector Replacement - Rear Door (Service and Repair) .
6. Install the door module.
7. Install the door trim panel. Refer to Trim Panel Replacement - Side Rear Door Service and Repair