Turn Signal Switch: Service and Repair

1. Disconnect battery ground cable.
2. Remove steering wheel using a suitable puller. Scribe alignment mark between steering wheel and shaft to ensure proper installation. On models with tilt steering columns, place column in lowest position during steering wheel removal.
3. Remove upper and lower steering column covers.
4. Remove wiring harness retaining straps, if equipped, then disconnect electrical connectors.
5. Remove column switch assembly.
6. Reverse procedure to install, noting the following:
a. Ensure column switch is properly aligned with steering shaft center.
b. Attach switch wiring along column tube as close to center line as possible.
c. Retain wiring using suitable retaining straps to prevent contact with other parts.