Camber

FRONT




WITH TWO WHEEL DRIVE

1. Using tool No. MB990805 to hold upper arm shaft to crossmember bolt in position, remove nut from engine compartment side and adjust the number of shims between upper arm shaft and crossmember.
2. The normal shim pack thickness is 0.16 inch. A change of 0.024 inch in thickness of the shim pack will provide a change of approximately 2/15 degree in camber adjustment.




WITH FOUR WHEEL DRIVE

Adjust number of shims between upper arm shaft and arm post of side frame. The normal shim package thickness is 0.12 inch. A change of 0.039 inch in thickness of shim pack will provide a change of approximately 13 minutes in camber adjustment. Camber adjusting shims are available in thicknesses of 0.039 and 0.079 inch.




REAR

Rear camber is pre-set during vehicle assembly and cannot be adjusted. If camber is not within specifications, check for worn or damaged suspension component, and damaged or deformed floor pan or body and repair as needed.