12B Check Fuel Control Wire

1. With logic module white electrical connector disconnected, place ignition switch in the Off position.
2. Disconnect jumper wire from terminal No. 2 of logic module electrical connector.
3. Disconnect power module 12 terminal electrical connector.
4. Connect an ohmmeter between terminal No. 1 of power module 12 terminal connector and ground.
5. If ohmmeter indicates continuity, replace power module.

CAUTION: Before replacing the power module check the terminal in cavity No. 1 of the 12-way connector to make sure it is not spread apart causing a poor connection.

6. If ohmmeter does not indicate continuity, repair wire for an open circuit.