15H Power Circuit For 8 Volt Output

*** UPDATED BY TSB #18-61-86

1. Place ignition switch in the Off position.
2. Disconnect power module 12 way electrical connector.
3. Connect a voltmeter between terminal No. 12 of power module 12 way electrical connector and ground.
4. Place ignition switch in the Run position.
5. If voltmeter reading is at least 7 volts check and repair wiring from terminal No. 12 of the power module electrical connector to logic module for open or short circuit.

NOTE: Check the terminal in cavity No. 12 to make sure it is not spread apart causing a poor connection.

6. If voltmeter indicates 0 voltage, proceed to step I.