15J Power Circuit For 8 Volt Output

1. Place ignition switch in the Off position.
2. Disconnect 12 way electrical connector from power module. Connect a voltmeter to terminal No. 12 of the power module and ground.
3. Place ignition switch in Run position.
4. If voltmeter reads at least 7 volts, repair the wire in cavity No. 12 of the power module 12 way connector for an open circuit to the logic module.

NOTE: Check the terminal in cavity No. 12 to make sure it is not spread apart causing a poor connection.

5. If voltmeter reads 0 volts, proceed to Step K.