Distributor Assembly

Fig. 7 Distributor housing seal installation:

Fig. 8 Installing breaker assembly:

1. Lubricate distributor housing seal with suitable grease and install into distributor housing, Fig. 7.
2. Install distributor shaft and bearing assembly into distributor housing.
3. Install distributor drive gear onto shaft and align marks made during disassembly.
4. Install drive gear roll pin, then install bearing retainer and retaining screws.
5. Install breaker assembly and retaining screws, Fig. 8.
6. Install vacuum chamber onto distributor housing and secure with retaining screws.
7. Install pickup coil and ECU igniter as an assembly into housing, then install retaining screws.
8. Install wire retaining clamp and governor assembly. If governor assembly was disassembled, check to ensure that governor springs are installed in original positions.
9. Install governor assembly retaining screw and rotor.