Front Door Window Regulator

REMOVAL STEPS
1. Door trim
2. waterproof film
3. Glass
4. Door glass pad
5. Window glass holder
6. Door window regulator

NOTE: Reverse the removal procedures to reinstall

SERVICE POINTS OF REMOVAL





5. Removal Of Window Glass Holder
Remove the window glass holder from the door window regulator.

6. Removal Of Door Window Regulator





1. Remove the mounting bolts.





2. Pull out door window regulator through the across hole.

SERVICE POINTS OF INSTALLATION
6. Application Of Grease To Door Window Regulator
1. Apply the specified grease to the regulator rotating and sliding parts.

Specified grease: MOPAR Multipurpose Grease Part Number 2932524 or equivalent





2. If the door glass has been removed from the glass holder, reinstall in the position shown in the illustration.

Standard value: 73 - 74.5 mm (2.87 - 2.93 in.)





3. Raise the door glass fully, and then adjust the following items so that the door glass fits evenly into the door glass channel all the way around:
a. Loosen the roller guide mounting screws, and then the slant of the glass in the front-to-back direction.





b. Lower the door glass until the holder reaches the access hole, loosen the door glass holder mounting screws, and then adjust the front-to-back position of the glass.





c. Loosen the front lower sash mounting screws, and then adjust the front-to-back position.





2. Application Of Sealant To Waterproof Film
Apply specified sealant at the position shown in the illustration, and then attach the waterproof film.

Specified sealant: MOPAR Rope Caulk Sealer 3/16 x 80" roll Part Number 4026044 or equivalent