Blower Motor: Service and Repair

REMOVAL AND INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the glove box.
3. On vehicles equipped with A/C, disconnect the (2) vacuum lines from the recirculating air door actuator.
4. Disconnect blower lead wire connector.
5. Remove (2) screws at the top of the blower housing, securing it to the unit cover.

Blower Housing (Typical):

6. Remove (5) screws from around the blower housing and separate the blower housing from the unit.

Blower Motor And Wheel Assembly:

7. Remove (3) screws, securing the blower and wheel assembly to the heater or A/C unit housing and separate the assembly from the unit.

8. To install, reverse the preceding operation.