Rear Door Window Glass: Service and Repair

REMOVAL
1. Remove door trim panel and water shield.
2. Remove inner door belt weatherstrip.
3. Loosen door glass jounce bumper.
4. Lower door glass to bottom of door.

Rear Door Glass:

5. Remove nuts holding door glass to window regulator lift plate.
6. Disengage door glass from regulator.
7. Lift door glass upward out of the opening at the top of door.

INSTALLATION
1. Lower door glass through opening in top of door and into position in the window regulator.
2. Install nuts holding door glass to window regulator lift plate.
3. Raise glass and tighten window inner belt stabilizer.
4. Install inner door belt weatherstrip, watershield and door trim panel.
5. Operate window and check for interference. Adjust glass as necessary