Cruise Control Servo: Service and Repair

1. Disconnect battery cables, then remove battery thermoguard, battery hold down and battery.
2. Remove power distribution center from back of battery tray.
3. Disconnect speed control cable from throttle body.
4. Remove screw holding support strut to front of battery tray.
5. Remove top battery tray fasteners.
6. Slide tray up and disconnect speed control servo wiring and vacuum harness from servo.
7. Remove attaching nuts and then speed control assembly from bottom of battery tray.
8. Reverse procedure to install ensuring servo wiring connector points toward the left front corner of vehicle when battery tray is installed. Torque nuts to 60 inch lbs.